MCBSTM32EXL Keil, MCBSTM32EXL Datasheet - Page 654

• Manufacturer Part Number: MCBSTM32EXL
• Description: BOARD EVALUATION FOR STM32F103ZE
• Manufacturer: Keil

Specifications of MCBSTM32EXL

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Universal synchronous asynchronous receiver transmitter (USART)
25.3
654/995
●
●
●
●
●
●
●
●
●
●
USART functional description
The interface is externally connected to another device by three pins (see
USART bidirectional communication requires a minimum of two pins: Receive Data In (RX)
and Transmit Data Out (TX):
RX: Receive Data Input is the serial data input. Oversampling techniques are used for data
recovery by discriminating between valid incoming data and noise.
TX: Transmit Data Output. When the transmitter is disabled, the output pin returns to its I/O
port configuration. When the transmitter is enabled and nothing is to be transmitted, the TX
pin is at high level. In single-wire and smartcard modes, this I/O is used to transmit and
receive the data (at USART level, data are then received on SW_RX).
–
Single wire half duplex communication
Configurable multibuffer communication using DMA (direct memory access)
–
Separate enable bits for Transmitter and Receiver
Transfer detection flags:
–
–
–
Parity control:
–
–
Four error detection flags:
–
–
–
–
Ten interrupt sources with flags:
–
–
–
–
–
–
–
–
–
–
Multiprocessor communication - enter into mute mode if address match does not occur
Wake up from mute mode (by idle line detection or address mark detection)
Two receiver wakeup modes: Address bit (MSB, 9
0.5, 1.5 Stop Bits for Smartcard operation
Buffering of received/transmitted bytes in reserved SRAM using centralized DMA
Receive buffer full
Transmit buffer empty
End of Transmission flags
Transmits parity bit
Checks parity of received data byte
Overrun error
Noise error
Frame error
Parity error
CTS changes
LIN break detection
Transmit data register empty
Transmission complete
Receive data register full
Idle line received
Overrun error
Framing error
Noise error
Parity error
Doc ID 13902 Rev 9
th
bit), Idle line
Figure
238). Any
RM0008