MCBSTM32EXL Keil, MCBSTM32EXL Datasheet - Page 665

• Manufacturer Part Number: MCBSTM32EXL
• Description: BOARD EVALUATION FOR STM32F103ZE
• Manufacturer: Keil

Specifications of MCBSTM32EXL

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

RM0008
25.3.4
Note:
4.
Fractional baud rate generation
The baud rate for the receiver and transmitter (Rx and Tx) are both set to the same value as
programmed in the Mantissa and Fraction values of USARTDIV.
USARTDIV is an unsigned fixed point number that is coded on the USART_BRR register.
The baud counters are updated with the new value of the Baud registers after a write to
USART_BRR. Hence the Baud rate register value should not be changed during
communication.
How to derive USARTDIV from USART_BRR register values
Example 1:
If DIV_Mantissa = 0d27 and DIV_Fraction = 0d12 (USART_BRR = 0x1BC), then
Mantissa (USARTDIV) = 0d27
Fraction (USARTDIV) = 12/16 = 0d0.75
Therefore USARTDIV = 0d27.75
Example 2:
To program USARTDIV = 0d25.62
This leads to:
DIV_Fraction = 16*0d0.62 = 0d9.92
The nearest real number is 0d10 = 0xA
DIV_Mantissa = mantissa (0d25.620) = 0d25 = 0x19
Then, USART_BRR = 0x19A hence USARTDIV = 0d25.625
Example 3:
To program USARTDIV = 0d50.99
This leads to:
DIV_Fraction = 16*0d0.99 = 0d15.84
baud clock period during which nothing happens, followed by 1 normal stop bit period
during which sampling occurs halfway through. Refer to
page 675
2 stop bits: Sampling for 2 stop bits is done on the 8th, 9th and 10th samples of the
first stop bit. If a framing error is detected during the first stop bit the framing error flag
will be set. The second stop bit is not checked for framing error. The RXNE flag will be
set at the end of the first stop bit.
Tx/ Rx baud =
legend: f
for more details.
CK
Universal synchronous asynchronous receiver transmitter (USART)
- Input clock to the peripheral (PCLK1 for USART2, 3, 4, 5 or PCLK2 for USART1)
(16*USARTDIV)
Doc ID 13902 Rev 9
f
CK
Section 25.3.11: Smartcard on
665/995