MCBSTM32EXL Keil, MCBSTM32EXL Datasheet - Page 600

• Manufacturer Part Number: MCBSTM32EXL
• Description: BOARD EVALUATION FOR STM32F103ZE
• Manufacturer: Keil

Specifications of MCBSTM32EXL

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Serial peripheral interface (SPI)
23.4.2
600/995
An additional pin could be used when a master clock output is needed for some external
audio devices:
●
The I
master mode. This clock generator is also the source of the master clock output. Two
additional registers are available in I
configuration SPI_I2SPR and the other one is a generic I
SPI_I2SCFGR (audio standard, slave/master mode, data format, packet frame, clock
polarity, etc.).
The SPI_CR1 register and all CRC registers are not used in the I
SSOE bit in the SPI_CR2 register and the MODF and CRCERR bits in the SPI_SR are not
used.
The I
Supported audio protocols
The three-line bus has to handle only audio data generally time-multiplexed on two
channels: the right channel and the left channel. However there is only one 16-bit register for
the transmission or the reception. So, it is up to the software to write into the data register
the adequate value corresponding to the considered channel side, or to read the data from
the data register and to identify the corresponding channel by checking the CHSIDE bit in
the SPI_SR register. Channel Left is always sent first followed by the channel right (CHSIDE
has no meaning for the PCM protocol).
Four data and packet frames are available. Data may be sent with a format of:
●
●
●
●
When using 16-bit data extended on 32-bit packet, the first 16 bits (MSB) are the significant
bits, the 16-bit LSB is forced to 0 without any need for software action or DMA request (only
one read/write operation).
The 24-bit and 32-bit data frames need two CPU read or write operations to/from the
SPI_DR or two DMA operations if the DMA is preferred for the application. For 24-bit data
frame specifically, the 8 non-significant bits are extended to 32 bits with 0-bits (by hardware).
For all data formats and communication standards, the most significant bit is always sent
first (MSB first).
The I
PCMSYNC bits in the SPI_I2SCFGR register.
I
For this standard, the WS signal is used to indicate which channel is being transmitted. It is
activated one CK clock cycle before the first bit (MSB) is available.
2
S Phillips standard
MCK: Master Clock (mapped separately) is used, when the I
mode (and when the MCKOE bit in the SPI_I2SPR register is set), to output this
additional clock generated at a preconfigured frequency rate equal to 256 × F
F
16-bit data packed in 16-bit frame
16-bit data packed in 32-bit frame
24-bit data packed in 32-bit frame
32-bit data packed in 32-bit frame
2
2
2
S
S uses its own clock generator to produce the communication clock when it is set in
S uses the same SPI register for data transfer (SPI_DR) in 16-bit wide mode.
S interface supports four audio standards, configurable using the I2SSTD[1:0] and
is the audio sampling frequency.
Doc ID 13902 Rev 9
2
S mode. One is linked to the clock generator
2
S configuration register
2
2
S mode. Likewise, the
S is configured in master
S
RM0008
, where