MCBSTM32EXL Keil, MCBSTM32EXL Datasheet - Page 748

• Manufacturer Part Number: MCBSTM32EXL
• Description: BOARD EVALUATION FOR STM32F103ZE
• Manufacturer: Keil

Specifications of MCBSTM32EXL

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

USB on-the-go full-speed (OTG_FS)
748/995
Bits 16:13 PTCTL: Port test control
Bits 11:10 PLSTS: Port line status
Bit 12 PPWR: Port power
Bit 9 Reserved
Bit 8 PRST: Port reset
Bit 7 PSUSP: Port suspend
The application writes a nonzero value to this field to put the port into a Test mode, and the
corresponding pattern is signaled on the port.
The application uses this field to control power to this port, and the core clears this bit on an
overcurrent condition.
Indicates the current logic level USB data lines
When the application sets this bit, a reset sequence is started on this port. The application
must time the reset period and clear this bit after the reset sequence is complete.
The application must leave this bit set for a minimum duration of at least 10 ms to start a reset
on the port. The application can leave it set for another 10 ms in addition to the required
minimum duration, before clearing the bit, even though there is no maximum limit set by the
USB standard.
The application sets this bit to put this port in Suspend mode. The core only stops sending
SOFs when this is set. To stop the PHY clock, the application must set the Port clock stop bit,
which asserts the suspend input pin of the PHY.
The read value of this bit reflects the current suspend status of the port. This bit is cleared by
the core after a remote wakeup signal is detected or the application sets the Port reset bit or
Port resume bit in this register or the Resume/remote wakeup detected interrupt bit or
Disconnect detected interrupt bit in the Core interrupt register (WKUINT or DISCINT in
OTG_FS_GINTSTS, respectively).
0000: Test mode disabled
0001: Test_J mode
0010: Test_K mode
0011: Test_SE0_NAK mode
0100: Test_Packet mode
0101: Test_Force_Enable
Others: Reserved
0: Power off
1: Power on
Bit [10]: Logic level of OTG_FS_FS_DP
Bit [11]: Logic level of OTG_FS_FS_DM
0: Port not in reset
1: Port in reset
0: Port not in Suspend mode
1: Port in Suspend mode
Doc ID 13902 Rev 9
RM0008