MCBSTM32EXL Keil, MCBSTM32EXL Datasheet - Page 838

• Manufacturer Part Number: MCBSTM32EXL
• Description: BOARD EVALUATION FOR STM32F103ZE
• Manufacturer: Keil

Specifications of MCBSTM32EXL

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Ethernet (ETH): media access control (MAC) with DMA controller
27.2.1
838/995
MAC core features
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
Supports 10/100 Mbit/s data transfer rates with external PHY interfaces
IEEE 802.3-compliant MII interface to communicate with an external Fast Ethernet
PHY
Supports both full-duplex and half-duplex operations
–
–
–
–
–
Preamble and start-of-frame data (SFD) insertion in Transmit, and deletion in Receive
paths
Automatic CRC and pad generation controllable on a per-frame basis
Options for automatic pad/CRC stripping on receive frames
Programmable frame length to support Standard frames with sizes up to 16 KB
Programmable interframe gap (40-96 bit times in steps of 8)
Supports a variety of flexible address filtering modes:
–
–
–
–
–
–
Separate 32-bit status returned for transmission and reception packets
Supports IEEE 802.1Q VLAN tag detection for reception frames
Separate transmission, reception, and control interfaces to the Application
Supports mandatory network statistics with RMON/MIB counters (RFC2819/RFC2665)
MDIO interface for PHY device configuration and management
Detection of LAN wakeup frames and AMD Magic Packet™ frames
Receive feature for checksum off-load for received IPv4 and TCP packets
encapsulated by the Ethernet frame
Enhanced receive feature for checking IPv4 header checksum and TCP, UDP, or ICMP
checksum encapsulated in IPv4 or IPv6 datagrams
Support Ethernet frame time stamping as described in IEEE 1588-2002. Sixty-four-bit
time stamps are given in each frame’s transmit or receive status
Two sets of FIFOs: a 2-KB Transmit FIFO with programmable threshold capability, and
a 2-KB Receive FIFO with a configurable threshold (default of 64 bytes)
Receive Status vectors inserted into the Receive FIFO after the EOF transfer enables
multiple-frame storage in the Receive FIFO without requiring another FIFO to store
those frames’ Receive Status
Supports CSMA/CD Protocol for half-duplex operation
Supports IEEE 802.3x flow control for full-duplex operation
Optional forwarding of received pause control frames to the user application in full-
duplex operation
Back-pressure support for half-duplex operation
Automatic transmission of zero-quanta pause frame on deassertion of flow control
input in full-duplex operation
Up to four 48-bit perfect (DA) address filters with masks for each byte
Up to three 48-bit SA address comparison check with masks for each byte
64-bit Hash filter (optional) for multicast and unicast (DA) addresses
Option to pass all multicast addressed frames
Promiscuous mode support to pass all frames without any filtering for network
monitoring
Passes all incoming packets (as per filter) with a status report
Doc ID 13902 Rev 9
RM0008