MCBSTM32EXL Keil, MCBSTM32EXL Datasheet - Page 61

• Manufacturer Part Number: MCBSTM32EXL
• Description: BOARD EVALUATION FOR STM32F103ZE
• Manufacturer: Keil

Specifications of MCBSTM32EXL

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

RM0008
switched off. SRAM and register contents are lost except for registers in the Backup domain
and Standby circuitry (see
Entering Standby mode
Refer to
In Standby mode, the following features can be selected by programming individual control
bits:
●
●
●
●
Exiting Standby mode
The microcontroller exits Standby mode when an external Reset (NRST pin), IWDG Reset,
a rising edge on WKUP pin or an RTC alarm occurs. All registers are reset after wakeup
from Standby except for
After waking up from Standby mode, program execution restarts in the same way as after a
Reset (boot pins sampling, vector reset is fetched, etc.). The SBF status flag in the
control/status register (PWR_CSR)
Refer to
Table 12.
I/O states in Standby mode
In Standby mode, all I/O pins are high impedance except:
●
●
●
Mode entry
Mode exit
Wakeup latency
Standby mode
Independent watchdog (IWDG): the IWDG is started by writing to its Key register or by
hardware option. Once started it cannot be stopped except by a reset. See
Section 17.3
real-time clock (RTC): this is configured by the RTCEN bit in the Backup domain control
register (RCC_BDCR)
Internal RC oscillator (LSI RC): this is configured by the LSION bit in the Control/status
register (RCC_CSR).
External 32.768 kHz oscillator (LSE OSC): this is configured by the LSEON bit in the
Backup domain control register (RCC_BDCR)
Reset pad (still available)
TAMPER pin if configured for tamper or calibration out
WKUP pin, if enabled
Table 12
Table 12
Standby mode
for more details on how to enter Standby mode.
for more details on how to exit Standby mode.
in
Section 17: Independent watchdog
WFI (Wait for Interrupt) or WFE (Wait for Event) while:
– Set SLEEPDEEP in Cortex™-M3 System Control register
– Set PDDS bit in Power Control register (PWR_CR)
– Clear WUF bit in Power Control/Status register (PWR_CSR)
WKUP pin rising edge, RTC alarm, external Reset in
Reset.
Regulator start up. Reset phase
Power control/status register
Figure
Doc ID 13902 Rev 9
4).
indicates that the MCU was in Standby mode.
Description
(PWR_CSR).
(IWDG).
Power control (PWR)
NRST
pin, IWDG
Power
61/995