HD6417760BL200AV Renesas Electronics America, HD6417760BL200AV Datasheet - Page 1187

• Manufacturer Part Number: HD6417760BL200AV
• Description: SH4 7760, 17 X17 256BGA, LCDC, U
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7750r

Specifications of HD6417760BL200AV

• Core Processor: SH-4
• Core Size: 32-Bit
• Speed: 200MHz
• Connectivity: Audio Codec, CAN, EBI/EMI, FIFO, I²C, MFI, MMC, SCI, Serial Sound, SIM, SPI, USB
• Peripherals: DMA, LCD, POR, WDT
• Number Of I /o: 69
• Program Memory Type: ROMless
• Ram Size: 48K x 8
• Voltage - Supply (vcc/vdd): 1.4 V ~ 1.6 V
• Data Converters: A/D 4x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 256-BGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -

(TFT module)
The table above shows the states of the power supply, display data, and timing signals for the
typical LCD module in its active and stopped states. Some of the supply voltages described may
not be necessary, because some modules internally generate the power supply required for high-
voltage systems from the logic-level power-supply voltage.
Warning regarding display-off mode (LCDC stopped):
When LCD module power-supply control-sequence processing is in use by the LCDC and the
supply of power is cut off while the LCDC is in its display-on mode, the LCDC may not function
properly. In the worst case, the connected LCD module may be damaged.
30.4.7
Operation in hardware-rotation mode is described below. Hardware-rotation mode can be thought
of as using a landscape-format LCD panel instead of a portrait-format LCD panel by placing the
landscape-format LCD panel as if it were a portrait-format panel. Whether the panel is intended
for use in landscape or portrait format is thus no problem. The panel must, however, be within 320
pixels wide.
When conducting hardware rotation, the following five changes must be made from the settings
for no hardware rotation. (The following example is for a display at 8 bpp. At 16 bpp, the amount
of memory per dot will be doubled. The image size and register values used for rotation will thus
be different.)
1. The image data must be prepared for display in the rotated panel. (If 240 × 320 pixels will be
2. The register settings for the address of the image data must be changed (LDSARU and
State
Control Pin
Operating State
(Transitional State)
Stopped State
required after rotation, 240 × 320 pixel image data must be prepared.)
LDLAOR).
Operation for Hardware Rotation
Power Supply for
Logic
VCPWC
Supply
Supply
Supply
Display Data,
Timing Signal
LCD_CL2, LCD_CL1,
LCD_FLM,
LCD_M_DISP,
LCD_DATA
Supply
Supply
Rev. 2.00 Feb. 12, 2010 Page 1103 of 1330
Power Supply for
High-Voltage Systems
VEPWC
Supply
REJ09B0554-0200