HD6417760BL200AV Renesas Electronics America, HD6417760BL200AV Datasheet - Page 1188

• Manufacturer Part Number: HD6417760BL200AV
• Description: SH4 7760, 17 X17 256BGA, LCDC, U
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7750r

Specifications of HD6417760BL200AV

• Core Processor: SH-4
• Core Size: 32-Bit
• Speed: 200MHz
• Connectivity: Audio Codec, CAN, EBI/EMI, FIFO, I²C, MFI, MMC, SCI, Serial Sound, SIM, SPI, USB
• Peripherals: DMA, LCD, POR, WDT
• Number Of I /o: 69
• Program Memory Type: ROMless
• Ram Size: 48K x 8
• Voltage - Supply (vcc/vdd): 1.4 V ~ 1.6 V
• Data Converters: A/D 4x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 256-BGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -

3. LDLAOR should be power of 2 (when the horizontal width after rotation is 240 pixels,
4. Graphics software should also be set as in number 3.
5. LDSARU should be changed to represent the address of the data for the lower-left pixel of the
For example, the registers have been set up for the display of image data in landscape format (320
× 240), which starts from LDSARU = 0x0c001000, on a 320 × 240 LCD panel. The graphics
driver software is complete. Some changes are required to apply hardware rotation and use the
panel as a 240 × 320 display. If LDLAOR is 512, the graphics driver software uses this power of 2
as the offset for the calculation of the addresses of Y coordinates in the image data. Before setting
ROT to 1, the image data must be redrawn to suit the 240 × 320 LCD panel. LDLAOR will then
be 256 because the size has changed and the graphics driver software must be altered accordingly.
The point that corresponds to LDSARU moves from the upper left to the lower left of the display,
so LDSARU should be changed to 0x0c001000 + 256 * 319.
Rev. 2.00 Feb. 12, 2010 Page 1104 of 1330
REJ09B0554-0200
LDLAOR should be set to 256).
image rather than that of the data for the upper-left pixel of the image.
1) Normal mode
LCD panel
Image
LDSARU (Origin)
Origin
Image
Image
LDSARU + LDLAOR − 1
LDSARU + LDLAOR × LDVDLNR − 1(Destination)
Destination
Scanning origin is LDSARU.
Scanning is done in X direction,
from left to right.