HD6417760BL200AV Renesas Electronics America, HD6417760BL200AV Datasheet - Page 862

• Manufacturer Part Number: HD6417760BL200AV
• Description: SH4 7760, 17 X17 256BGA, LCDC, U
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7750r

Specifications of HD6417760BL200AV

• Core Processor: SH-4
• Core Size: 32-Bit
• Speed: 200MHz
• Connectivity: Audio Codec, CAN, EBI/EMI, FIFO, I²C, MFI, MMC, SCI, Serial Sound, SIM, SPI, USB
• Peripherals: DMA, LCD, POR, WDT
• Number Of I /o: 69
• Program Memory Type: ROMless
• Ram Size: 48K x 8
• Voltage - Supply (vcc/vdd): 1.4 V ~ 1.6 V
• Data Converters: A/D 4x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 256-BGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -

Bit
2
1
0
Rev. 2.00 Feb. 12, 2010 Page 778 of 1330
REJ09B0554-0200
Bit Name
PSS
PES
CCS
Initial Value R/W
0
0
0
R
R
R
Description
Port Suspend Status
This bit indicates the port is suspended or is in the
resume sequence. It is set to 1 by a
SetSuspendState write and cleared to 0 when
PSSC is set to 1 at the end of the resume interval.
This bit cannot be set to 1 when CCS is 0. This bit is
also cleared to 0 when PRSC is set to 1 at the end
of the port reset or when HC enters the USB
resume state. When an upstream resume is in
progress, it should propagate to HC.
0: Port is not in suspend state
1: Port is in suspend state
Port Enable Status
This bit indicates whether the port is enabled or
disabled. The root hub may clear this bit to 0 when
detecting an overcurrent condition, disconnect
event, switched-off power, or operational bus error
such as babble. This change also sets PESC to 1.
HCD sets this bit to 1 by writing 1 to this bit and
clears to 0 this bit by writing CSS. This bit cannot be
set to 1 when CCS is 0. This bit is also set, if not
already, on completion of a port reset when PRSC
is set or port suspend when PSSC is set.
0: Port is disabled
1: Port is enabled
Current Connect Status
This bit reflects the current state of the downstream
port.
0: Device is not connected to port
1: Device is connected to port
Note: This bit is always read 1 when the attached
device is non-removable (DR = H'0002).